MAX30102 Heart Rate Sensor Module Puls Detection Blood Oxygen Sensor Concentration Test Module for arduino STM32

(1 omtale)

kr 39,00 inkl. mva

På lager og sendes omgående! (40)

Klikk her om du har funnet varen billigere et annet sted!

7000000087752 Produktnr: 0105-HEART-NB198 Kategori:

Beskrivelse

1 Pcs MAX30102 Heart Rate Sensor Module Puls Detection Blood Oxygen Sensor Concentration Test Module for arduino STM32

Description:
The MAX30102 is an integrated pulse oximeter and heart rate monitor biosensor module. It integrates a red LED and an infrared LED, photodetector, optical device, and low-noise electronic circuitry with ambient light suppression. Wear the device for heart rate and blood oxygen collection, and wear it on your fingers, earlobe and wrist. The standard I2C-compatible communication interface can transfer the collected values to the Arduino and other microcontrollers for heart rate and blood oxygen calculation. In addition, the chip can also shut down the module through software, the standby current is close to zero, and the power supply is always maintained. Because of its excellent performance, the chip is widely used in the Samsung Galaxy S series mobile phones. The chip integrates a glass cover to effectively eliminate external and internal light interference and has the best reliable performance.
Parameter:
LED peak wavelength: 660nm/880nm
LED supply voltage: 3.3-5V
Detection signal type: light reflection signal (PPG)
Output signal interface: I2C interface
Communication interface voltage: 18-3.3V-5V (optional)
Board reserved assembly hole size: 0.5X8.5mm
Working principle: Light-dissolving method: measuring the pulse and blood oxygen saturation by using human tissue to cause different light transmittance when the blood vessel beats; Light source: a specific wavelength illuminating pole tube selective for oxyhemoglobin (HbO2) and hemoglobin (Hb) in arterial blood; Transmittance is converted into electrical signal: the volume of the arterial pulsation is changed to the light transmittance of the light. At this time, the light is reflected by the human body tissue by photoelectric conversion, converted into an electrical signal and amplified and output.
Pin Description:
VIN: main power supply input terminal 1.8V-5V; 3-bit pad: Select the pull-up level of the bus, depending on the pin master voltage, select 1.8v or 3.3V (this terminal contains 3.3V and above)
SCL: Connect the clock of I2C bus;
SDA: data connected to the I2C bus;
 INT : Interrupt pin of the MAX30102 chip;
 RD: RED of the MAX30102 chip, LED ground terminal, – generally not connected;
 IRD: The IR, LED grounding of the MAX30102 chip is generally not connected;
GND :Ground wire
Package Included:
1 x MAX30102 Heart Rate Sensor Module
NB. Enheten er ikke ment for profesjonell bruk, men deretter i utvikling og testsammenheng.
MAX30102
MAX30102

1 omtale for MAX30102 Heart Rate Sensor Module Puls Detection Blood Oxygen Sensor Concentration Test Module for arduino STM32

  1. Jan Olav (bekreftet eier)

Skriv en omtale

Din e-postadresse vil ikke bli publisert. Obligatoriske felt er merket med *

×






Skriv inn din epostadresse så vi kan sende deg en mail når varen er på lager:
X
0
    0
    Handlekurv
    Tøm handlekurvTilbake til butikk
      Calculate Shipping
      Apply Coupon